Photo counter circuit
Above is the circuit of the photo counter. Working of the circuit is simple. When light falling on the photodiode is interrupted, counter CD4040 advances by one and the binary output is shown on the LED display. For example, if light falling on the photodiode is interrupted three times, LED1 and LED2 glow to indicate three counts.
Please note that only two output connections (LED1 for LSB and LED12 for MSB) are shown in the circuit. Others are indicated by dotted lines but are not shown here. You can connect the remaining outputs of IC1 with other LEDs (LED2 through LED11, not shown here) for appropriate counting.
Construction & testing
After assembling the circuit on a compact circuit board and giving it necessary camouflage, charge the battery once. Put the unit in a cupboard or drawer, close the same and open it. You will find that the reading of the counter has incremented by ‘1’ and can be read in binary fashion through LEDs. The reset button is used to reset the counter. The prototype in Fig. 2 shows the size of the gadget without LEDs.
Try using a separate power source to power the reading LEDs.
The project was first published in December 2010 and has recently been updated.