Circuit and working of Touch Switch
A simple touch switch circuit diagram is shown in figure 1. It is built around four BC547 transistors (T1 through T4), a 5V single changeover relay (RL1), two 1N4007 diodes (D1 and D2) and two touch plates (TP1 and TP2). The circuit works off 5V DC.
Working of the circuit is straightforward. When TP1 is touched, the base voltages of transistors T1 and T4 go high. As a result, relay RL1 energises to activate the load (light or fan) through relay contacts.
When TP2 is touched, the base voltage of transistor T2 goes high and transistor T3 conducts. The voltage developed across resistor R2 de-energises relay RL1 to de-activate the load.
Touch plates TP1 and TP2 can be made from copper wires or copper plates.
Construction and testing
An actual-size PCB layout for the touch switch is shown in figure 2 and its components layout in figure 3. After assembling the circuit, enclose it in a suitable box. Affix the touch plates on the front panel of the box such that you can touch them easily.