Friday, November 1, 2024

Ask for advice on the problem of L298N drive motor

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #86844
    Anonymous
    Inactive

    A small car:
    One DC geared motor controls two front wheels and one steering gear

    One motor controls two rear wheels,
    So the speed and direction of the front and rear wheels are the same,
    Can one motor pin of L298N be used to control two drive motors at the same time (in parallel), and then the other motor pin can control the servo.
    L298N is dual.

    #86963
    Anonymous
    Inactive

    Well, I don’t really get you. But maybe datasheet of the part can give you some hints.

    #87735
    Ashwini Sinha
    Keymaster

    L298N gives digital 1 and zero while the servo motor drive on the PWM signal so technically it’s hard o do. But you can try hardware to hack here open the servo and disconnect the servo motor PWM driver circuit and then connect the servo motor terminals directly to L298N motor output

    #87736
    Ashwini Sinha
    Keymaster

    L298N gives digital 1 and zero while the servo motor drive on the PWM signal so technically it’s hard o do. But you can try hardware to hack here open the servo and disconnect the servo motor PWM driver circuit and then connect the servo motor terminals directly to L298N motor output

    #87737
    Ashwini Sinha
    Keymaster

    L298N gives digital 1 and zero while the servo motor drive on the PWM signal so technically it’s hard o do. But you can try hardware to hack here open the servo and disconnect the servo motor PWM driver circuit and then connect the servo motor terminals directly to L298N motor output

    #87738
    Ashwini Sinha
    Keymaster

    L298N gives digital 1 and zero while the servo motor drive on the PWM signal so technically it’s hard o do. But you can try hardware to hack here open the servo and disconnect the servo motor PWM driver circuit and then connect the servo motor terminals directly to L298N motor output

    #87739
    Ashwini Sinha
    Keymaster

    L298N gives digital 1 and zero while the servo motor drive on the PWM signal so technically it’s hard o do. But you can try hardware to hack here open the servo and disconnect the servo motor PWM driver circuit and then connect the servo motor terminals directly to L298N motor output

Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.