While repairing or installing electrical machines in a building, the AC mains power supply is switched off from the mains electrical switchboard installed outside...

Before electronic circuits based on printed circuit boards (PCBs) found their advent in industrial applications, electrical conductor wires were protected against short-circuits by applying...

This video shows how to build a radio in less than 1 minute. There's even a schematic in the end of the video, plus...

Carbon dioxide laser-based range finders and laser radar and helium-neon laser-cavity-based ring-laser gyroscope inertial navigation sensors are among the common military applications exploiting use...

Q. What is the most important design characteristic of a wearable device that an engineer should keep in mind? A. An important characteristic that influences...

By Dilin Anand and Anagha P Branded as the most over-hyped technology by Garner’s hype cycle report, the Internet of Things (IoT) has seen a...

Power and automation are two areas that stand to see significant gains from modern sensor, processing and communication technology. Vivek Sharma, regional vice president, greater...

If you have a simple Arduino project that uses only a few pins, you might be able to shrink it down to a single...

Use your old hard drive to turn into a Speaker with this Do It Yourself video. Courtesy: afrotechmods  

Altium Designer—an EDA software package for printed circuit board, FPGA and embedded software design. It is developed and marketed by Altium Limited of Australia....