A lot of accidents happen every day due to drunk driving. This is a very useful circuit for testing whether a driver is drunk or not. The circuit is easy to use, inexpensive and indicates various levels of alcohol consumption through LEDs.
Circuit and working
Fig. 1 shows a circuit of the alcohol level tester. Alcohol sensor MQ3 is used here to detect the alcohol fumes’ concentration.
The number of glowing LEDs indicates the concentration level of alcohol detected by the sensor. Resistor R1 and preset VR1 are used to calibrate the output voltage from the sensor.
Construction and testing
An actual-size, single-side PCB for the alcohol level tester is shown in Fig. 2 and its component layout in Fig. 3. After assembling the circuit on PCB, enclose it in a suitable case.
Download PCB and component layout PDFs: click here
Switch on the circuit and verify the test points mentioned in the table. Before using the circuit, vary VR1 until LED1 and LED2 glow when the sensor is in normal environment. Now open the cork of an alcohol bottle and bring it near sensor1. You will notice that LED3, LED4 and LED5 also start glowing. As you bring the alcohol bottle’s open mouth very close to sensor1, all the LEDs (LED1 through LED10) will start glowing.
We do not recommend that you actually consume some alcohol to test the circuit. The above test with a bottle of alcohol, or its sample in a small glass, should suffice for most purposes. Until you find a drunk, of course!
The author is an electronics hobbyist.