For soldering larger things like 10 gauge copper wire, motor casings, or large heat sinks, you may need upwards of a 50 Watt iron or more. Soldering irons are available in different wattage and usually run at 230V AC mains. However, these have no temperature control. Low-voltage soldering irons (e.g. 12V) generally form part of a soldering station and are designed to be used with a temperature controller. A proper temperature controlled soldering iron or station is expensive. Here is a simple circuit that provides manual control of the temperature of an ordinary 12V AC soldering iron.
Soldering iron temperature controller circuit
Here is a simple soldering iron temperature controller circuit to control the temperature of a soldering iron. It is especially useful if the soldering iron is to be kept on for long since you can control the heat dissipation from the iron. When a soldering iron is switched on, the iron takes time to reach the solder’s melting point. Simply connect this circuit to the soldering iron as shown in the figure and the iron reaches the solder’s melting point quickly.
The circuit consists of TRIAC1, DIAC1, potentiometer VR1, a resistor & a capacitor. Triacs are widely used in AC power control applications. They are able to switch high voltages and high levels of current, and over both parts of an AC waveform. This makes triac circuits ideal for use in a variety of applications where power switching is needed. One particular use of triac circuits is in light dimmers for domestic lighting, and they are also used in many other power control situations including motor control.
A diac is a full-wave or bi-directional semiconductor switch that can be turned on in both forward and reverse polarities. The name diac comes from the words Diode AC switch. The diac is an electronics component that is widely used to assist even triggering of a triac when used in AC switches and as a result they are often found in light dimmers such as those used in domestic lighting. A typical diac-triac circuit is used for smooth control of ac power to a heater.
Triac BT136 is fired at different phase angles to get temperatures varying from zero to maximum. A diac is used to control the triac firing in both directions. Potentiometer VR1 is used for setting the temperature of the soldering iron.
The circuit can be housed in a box with the potentiometer fixed on the side such that its knob can be used from outside the box to adjust the soldering iron’s temperature.
The article was first published in November 2004 and has recently been updated.