The quartz clock circuit has two outputs that drive a coil. One of them (which produces a pulse every two seconds) is used to drive counter CD4040, which can count up to 4096.
You can set the time duration as per your requirement using DIP switches. Each switch has its own set time duration. The desired time is set with Q5 to Q12 outputs via DIP switches 1 through 8 (refer the table). For example, if you want to set the time duration to 68 minutes, shift switch 8 to ‘on’ position. This will make Q12 high. If two switches are ‘on,’ the time duration set will be equal to the sum of individual time durations. You can set maximum time duration of 136 minutes (which is the sum of the outputs of all the switches) by making all the switches ‘on.’ The outputs of the counter pass through diodes D5 through D12.
Working of the circuit is simple. When all the selected outputs go high, transistor T3 conducts. As a result, the buzzer sounds until it is reset. At the same time, transistor T2 also conducts to inhibit the clock input and stop the counter from further counting.
Assemble the circuit on a general-purpose PCB and enclose in a small plastic cabinet along with the quartz-clock PCB. Mount the DIP switch on the front side of the panel for easy setting of the required time duration.
The circuit is powered by a 3.6V Ni-Cd rechargeable battery, which makes the unit compact. The battery is charged by a 5V supply as shown in the circuit. The quiescent current of the timer is very low. A 60mA battery will last long enough at this rate of power consumption. Some quartz clocks come with an inbuilt alarm that has an enable pin. This does away with the need for an external buzzer, making the circuit compact.